Page 8 QTS-CLX-PVX September 2009
Summary of Operations
The following is a short summary of the steps typically followed. Refer to the
appropriate manual section for details.
Install the QTS-CLX-PVX module in the
ControlLogix chassis
Set the module mode to monitor (the default)
Connect the module to the Control I/O bus
Autoconfigure the module from the PROVOX
Control I/O bus
Configure the module in RSLogix 5000
Decide if you are going to use monitor mode to
develop and test your application
Disconnect the PROVOX master
Change the module mode to master
Save the configuration and download it to the
module
Create aliases for RSLogix 5000
Import the aliases into RSLogix 5000
Use the aliases to access data
Comments to this Manuals