ProSoft Technology ProLinx S3964R User Manual download pdf (Page 16)

S3964R ♦ ProLinx Gateway Configure the Gateway

Siemens 3964R Protocol Driver Manual

Page 16 of 64 ProSoft Technology, Inc.

April 14, 2009

2.1.2 [3964R Port x]

This section defines the port configuration for the 3964R device.

Enable

Yes or No

This parameter specifies whether to enable or disable the port. No = Port

Disabled, Yes = Port Enabled.

RS Interface

0 = RS-232

1 = RS-422

2 = RS-485

This parameter is only used for Ports 1, 2, or 3 to configure the electrical

interface for the individual ports.

Important: This parameter should not be used for port 0. Use the jumper on the back of the

module to select the RS interface for Port 0.

Baud Rate

300 to 115200

This parameter specifies the baud rate to be used on the port. Valid values are

300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

No comments

ProSoft Technology ProLinx S3964R User Manual Page 16