ProSoft Technology ProLinx S3964R User Manual download pdf (Page 12)

MVI46-S3964R ♦ SLC Platform Start Here

Siemens 3964R Protocol

Page 12 of 74 ProSoft Technology, Inc.

1.4 Setting Jumpers

If you use an interface other than RS-232 (default), you must change the jumper

configuration to match the interface. The following illustration shows the MVI46-

S3964R jumper configuration:

The Setup Jumper acts as "write protection" for the module's flash memory. In

"write protected" mode, the Setup pins are not connected, and the module's

firmware cannot be overwritten. Do not jumper the Setup pins together unless

you are directed to do so by ProSoft Technical Support.

1.5 Install the Module in the Rack

If you have not already installed and configured your SLC processor and power

supply, please do so before installing the MVI46-S3964R module. Refer to your

Rockwell Automation product documentation for installation instructions.

Warning: You must follow all safety instructions when installing this or any other electronic

devices. Failure to follow safety procedures could result in damage to hardware or data, or even

serious injury or death to personnel. Refer to the documentation for each device you plan to

connect to verify that suitable safety procedures are in place before installing or servicing the

device.

After you have checked the placement of the jumpers, insert MVI46-S3964R into

the SLC™ chassis. Use the same technique recommended by Rockwell

Automation to remove and install SLC™ modules.

Warning: This module is not hot-swappable! Always remove power from the rack before

inserting or removing this module, or damage may result to the module, the processor, or other

connected devices.

1 Turn power OFF.

April 17, 2008

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 73 74

No comments

ProSoft Technology ProLinx S3964R User Manual Page 12