Start Here MVI46-S3964R ♦ SLC Platform
Siemens 3964R Protocol
ProSoft Technology, Inc. Page 9 of 74
1 Start Here
In This Chapter
System Requirements .............................................................................9
Package Contents ................................................................................. 10
Install ProSoft Configuration Builder Software....................................... 10
Setting Jumpers ....................................................................................12
Install the Module in the Rack ...............................................................12
Connect your PC to the Processor ........................................................ 14
Download the Sample Program to the Processor..................................14
Connect your PC to the Module ............................................................17
Installing the MVI46-S3964R module requires a reasonable working knowledge
of the Rockwell Automation hardware, the MVI46-S3964R Module and the
application in which they will be used.
Caution: It is important that those responsible for implementation can complete the
application without exposing personnel, or equipment, to unsafe or inappropriate working
conditions. Safety, quality and experience are key factors in a successful installation.
1.1 System Requirements
The MVI46-S3964R module requires the following minimum hardware and
software components:
Rockwell Automation SLC 5/02 M0/M1 capable processors (or newer), with
compatible power supply and one free slot in the rack, for the MVI46-S3964R
module. The module requires 800mA of available power.
Rockwell Automation RSLogix 500 programming software.
Rockwell Automation RSLinx communication software
Pentium® II 500 MHz minimum. Pentium III 733 MHz (or better)
recommended
Supported operating systems:
o Microsoft® Windows 98
o Windows NT® (version 4 with SP4 or higher)
o Windows 2000
o Windows XP
32 Mbytes of RAM minimum, 64 Mbytes of RAM recommended
50 Mbytes of free hard disk space (or more based on application
requirements)
April 17, 2008
Comments to this Manuals