ProSoft Technology ProLinx S3964R User Manual download pdf (Page 19)

Module Configuration MVI46-S3964R ♦ SLC Platform

Siemens 3964R Protocol

ProSoft Technology, Inc. Page 19 of 74

2 Module Configuration

In This Chapter

 Installation Instructions .......................................................................... 19



ProSoft Configuration Builder ................................................................ 20



[Module]................................................................................................. 24



[Backplane 46]....................................................................................... 25



[3964R Port x] .......................................................................................25



Download the Project to the Module...................................................... 27

2.1 Installation Instructions

The following setups/limitations are to be observed:

Please make sure that you are using an MVI46-S3964R with the original

parameters and image as delivered.

Jumper SETUP:

Please remove to run the MVI46-S3964R in application mode.

ATTENTION: Incorrect setting of the jumpers may cause damage to the MVI46-

S3964R module.

The remaining jumpers for PRT1 and PRT2 have to be set according to the

requirements of the user.

The communication partners are to be connected to the serial interface PRT1

and/or PRT2 of the MVI46-S3964R.

The serial parameters of the communication partners are to be set to 9600 Baud,

even parity, 8 bit and 1 stop bit if the standard parameters of the MVI46-S3964R

will be used.

The assignment of the RS-232 connection cable between PRT1/2 (9 pole) and

CP-544 (25 pole) is as follows:

PRT1/2 Pin Description CP 544 Pin Description

2 RxD 2 TxD

3 TxD 3 RxD

5 Gnd 7 Gnd

Important: The other pins of the RS-232 must not be used.

RS-485 operation is not possible.

April 17, 2008

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 73 74

No comments

ProSoft Technology ProLinx S3964R User Manual Page 19