ProSoft Technology RLXIC-EH User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 104
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
Hardware Installation of the RLXIC-EV RLXIC-EV Intelligent Cellular
User Manual RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon
ProSoft Technology, Inc. Page 25 of 104
March 10, 2010
4.3 Indicator Lights
When your RLXIC-EV is connected to power and
an antenna, there is a specific pattern to the lights
to indicate its operation mode.
Network - Indicates a successful connection
to the cellular network with an IP address
given, and a channel acquired.
Signal - Light shows the strength of the
signal, and may be nearly solid (strong signal)
or flashing (weaker signal). A slow flash
indicates a very weak signal.
4.3.1 RSSI LED Ranges
RSSI/Signal LED Status Ranges of RSSI (dBm)
On Solid Equal to or stronger than -69
Fast Blink -70 to -79
Normal blink -80 to -89
Slow Blink -90 to -99
Extinguished Equal to or weaker than -100
Activity - Lights will flash as data is transferred to and from the RLXIC-EV
modem on the remote network.
Power - Indicates the power adapter is connected, and there is power getting
to the RLXIC-EV.
The Reset button (on the left side of the RLXIC-EV) has two functions. If it is
quickly depressed and released, the modem will simply power cycle the
internal hardware. If, however, the reset is depressed and held
for 45
seconds (count 45 slowly, and wait for the power light to go off after the light
pattern stops), the ALEOS configuration settings will return to the factory
defaults.
4.3.2 Light Patterns
The LEDs on the front of the modem will respond in different patterns to indicate
modem states.
Normal - Each LED, mentioned above, is lit as applicable.
Start up - The LEDs will cycle from left to right.
Configuration Reset - The LEDs will cycle left to right, and then right to left 4
times.
Authentication Failure - The Network, Signal, and Activity LEDs blink every
2 seconds.
Data Retry - The Network, Signal, and Activity LEDs blink every 3 seconds.
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 103 104

Comments to this Manuals

No comments