ProSoft Technology RLXIC-EH User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 104
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
RLXIC-EV Intelligent Cellular Hardware Installation of the RLXIC-EV
RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon User Manual
Page 26 of 104 ProSoft Technology, Inc.
March 10, 2010
4.4 Mounting
An optional accessory for your RLXIC-EV is a DIN-rail mounting kit, which
includes a bracket. The bracket is designed to hold the modem in place on the
DIN-rail.
To install the radio in the mounting kit, follow these steps.
1 Mount the bracket using number 6 screws. There are two holes each, to
fasten screws, and minimum of one hole each end is required for mounting
bracket.
2 Position RLXIC-EV between Alignment ears.
3 Engage top groove in body of RLXIC-EV with two tabs.
4 Push on far side of RLXIC-EV in center so that it touches side of Bracket.
5 Press down and release when upper groove on far side of RLXIC-EV, aligns
with tabs.
6 Release to complete installation into mounting bracket.
To remove, press on the two edges of the modem and the brackets, as pointed
by arrows in the diagram provided below. By doing this, the modem will snap out
of the mounting bracket.
To mount the bracket on the DIN-rail, follow these steps
1 Position the mounting bracket on a 35 x 7.5mm DIN-rail at a slight angle with
the hook on the left side of the bracket hooked into the right side of the unit
on the left.
2 Rotate the bracket onto the DIN-rail with the top of the rail hooked under the
lip on the rear of the bracket.
3 Press the bracket down onto the DIN-rail until flush. The locking tab snaps
into position and locks the bracket to the DIN-rail.
4 If the bracket does not lock in place, use a screwdriver or similar device to
move the locking tab down, press the bracket flush with the DIN-rail and
release the locking tab to lock the bracket in place.
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 103 104

Comments to this Manuals

No comments